Upgrade Register Sensor Framing Lever Screw for the Axion Scanner

Orders typically ship within one business day when in stock.

A small upgrade that makes framing adjustments on your Axion Scanner easier. The register sensor assembly sits close to several other adjustments, and the original red round thumb screw that locks the framing position can be tricky to reach and turn in that space.

This lever screw replaces it and does the same job, but the lever extends out past the surrounding hardware, so you can loosen and tighten the framing lock with real leverage and without reaching into the crowded area. The lever is spring-loaded and ratcheting: pull it out, rotate it to the position you like, and release. Since locking and unlocking only takes about a quarter turn, you can park it wherever it stays clear of the other controls. It clears them fully at every framing position.

Made from metal for durability. A nylon washer is included to protect the assembly's surface from scratches as the lever turns.

Installation: It’s a drop-in replacement and needs no tools. Thread out the original screw and thread in the new one. Because the lever is long, you may need to remove the gate and push the register sensor assembly inward to give the lever room to rotate while threading.

Shipping note: The lever will not fit in the scanner’s original foam packaging. Keep the original red round thumb screw and reinstall it as the shipping lock screw whenever you need to pack the scanner for transport, then switch back to the lever screw once it’s set up again.